Videofied V7000GPRS Control Panel with GPRS and PSTN Communications

V7000GPRS Module is a wireless, battery operated security system control panel. The control panel is designed for residential and commercial security applications where video verification is needed or desired. The control panel is powered by four 3.6-volt lithium batteries (not Included) that can last up to four years, depending on the amount of system activity.

A built-in siren provides status beeps and alarm sounds. A Videofied CMA701 is required to program this Videofied Security System as system programming cannot be done from this alarm panel alone.

A dual-tamper function is active 24 hours, whether or not the system is armed. An alarm occurs if the control panel cover is removed, or if the control panel is removed from the mounting surface. Supervised Wireless Technology The VISIO, along with all VIDEOFIED® devices utilize patented S2View® - Spread Spectrum, VIDEOFIED®, Interactive, AES Encrypted Wireless technology, providing optimum signal integrity and security. Bi-directional RF communication paths between all system devices and the system control panel assure high signal reliability.

Radio jam detection identifies deliberate jamming of the system from outside parties. Integrated antennas eliminate protruding wires or rods that may be cumbersome when installing, are unsightly to consumers, and if damaged could lead to potential system communication problems. Supervision is accomplished by signal transmissions every eight minutes between each system device (excluding Keyfobs) and the control panel. These signal transmissions identify the unique identification code along with the current open/close state, tamper condition, serial number, manufacture date, software revision and battery status. Configuration/Programming Complete system configuration/programming can be done onsite using an alphanumeric keypad.

Video Verification Incorporating MotionViewerTM cameras into the security system allows for video verification of intrusion alarms (only when the Frontel reporting format is selected). When the system is armed and a motion-activated camera is activated by an intruder, the camera captures a 10-second digital video clip which is sent to the central monitoring station by the control panel. Customers can also receive video clips through Email.

24-hour dual-tamper function provides detection for both cover and wall removal. Control panel also monitors all system device tamper switches. The systems supports up to a maximum of 25 wireless modules/sensors. A maximum of 4 Areas can be configured. Area 1 is predefined from factory for entry/exit delay. Areas 2, 3, and 4 can be configured as needed.

19 Access codes, 4 - 6 digits long plus one installer access code for on-site programming only can be programmed. Configuration/Programming - on-site using alphanumeric keypads or off-site using Frontel remote control Software. Communication - reports to central monitoring station. System Can also report alarms to customer via digital voice phone calls or Email via the monitoring centre.

Video Verification - video resolution of 320 x 240 pixels, 0.2 lux sensitivity, 5-frames per second for about 10 seconds total recording time. 220K MPEG file. History/Event Log - maximum 4,000 events stored in flash memory that cannot be cleared or erased.

Applications > Residential and small commercial security system installations. > Temporary and portable video verification for: • Property • Construction sites • Assets • V.I.P. protection NOTE: Supplied without batteries or SIM Card/Account

695.00