The Videofied Wireless Copper Theft Kit comes complete with the following:   1 x Videofied V7000GPRS Control Panel with GPRS and PSTN Communications 4 x Videofied DCV751 Outdoor Sensors 1 x Videofied CMA 701 Wireless Portable Keypad   The Videofied V7000GPRS Module is a wireless, battery operated security system control panel. The control panel is designed for residential and commercial security applications where video verification is needed or desired. The control panel is powered by four 3.6-volt lithium batteries that can last up to four years, depending on the amount of system activity. A built-in siren provides status beeps and alarm sounds.    A dual-tamper function is active 24 hours, whether or not the system is armed. An alarm occurs if the control panel cover is removed, or if the control panel is removed from the mounting surface. . Bi-directional RF communication paths between all system devices and the system control panel assure high signal reliability. Radio jam detection identifies deliberate jamming of the system from outside parties. Integrated antennas eliminate protruding wires or rods that may be cumbersome when installing, are unsightly to consumers, and if damaged could lead to potential system communication problems.     Signal transmissions identify the unique identification code of each sensor along with the current open/close state, tamper condition, serial number, manufacture date, software revision and battery status.    Easy to understand text on a 2-line, 16-characters liquid-crystal (LCD) display prompts you for simple operation of your system.     The V7000GPRS is Compatibile with all VIDEOFIED® wireless devices. Supervision occurrs every 8 minutes (all devices except Keyfobs). 24-hour dual-tamper function provides detection for both cover and wall removal. Control panel also monitors all system device tamper switches. Supports 25 Videofied Wireless Devices maximum. 4 Areas maximum. Area 1 predefined from factory for entry/exit delay. Areas 2, 3, and 4 can be configured as needed.   Access codes - 19 maximum, 4 - 6 digits; one installer access code for on-site programming only.   Configuration/Programming - on-site using alphanumeric keypads or off-site using Frontel remote control Software.   Video Verification - video resolution of 320 x 240 pixels, 0.2 lux sensitivity, 5-frames per second for about 10 seconds total recording time. 220K MPEG file.   History/Event Log - maximum 4,000 events stored in flash memory that cannot be cleared or erased.   Applications > Residential and small commercial security system installations. > Temporary and portable video verification for: • Property • Construction sites • Assets • V.I.P. protection NOTE: Supplied without batteries or SIM Card/Account